readygaq.blogg.se - Install dvd cd

#Install dvd cd how to#
#Install dvd cd install#
#Install dvd cd drivers#
#Install dvd cd driver#

If it doesn't boot, you might have to format the partition with Windows XP on it first (you can use a portable Linux distro or BartPE to do it). External DVD Drive, USB 3.0 Portable CD/DVD-RW Drive/ DVD Player for Laptop CD ROM Burner Compatible with Laptop Desktop PC Windows Linux OS Apple Mac White. Partition the hard drive, and make a new partition about 4GB in size.ISO or disk contents to the computer over the network. This will mark the partition as bootable.Īfter that, you should be able to boot from that partition, and setup should start.Īlternative solution: Follow these #1 and #2 steps instead of those above (warning: I have not tried it) Run BOOTSECT /NT60 X:, where X: is the letter of the new partition. In that folder, there should be a program called BOOTSECT.EXE.Open a command prompt, and navigate to that folder. In the partition, there should be a boot folder.Extract the disc or ISO contents to the new partition.Format the hard drive, and create a new partition.Put the hard drive from the Windows XP computer in your Windows 7 machine.

#Install dvd cd drivers#

If you are using Windows 9x, ME, 2000, or XP, and if the drive is installed correctly, it should be detected automatically and installed when the computer first boots up.ĬD drivers are found on our CD-ROM, CD-R, CD-RW, and DVD drivers page.

#Install dvd cd driver#

For additional information about loading and configuring these drivers on your computer, see our CD-ROM driver page.

#Install dvd cd install#

If you are using MS-DOS, you need the MS-DOS driver and MSCDEX. Can You Install Using the CD-ROM or DVD Insert a blank, writeable CD into your computers CD or DVD burner. IDE/EIDE CD-ROM drives only require the one or two CD-ROM drives for the drives to work.

#Install dvd cd how to#

How to enter and exit the BIOS or CMOS setup.

Once verified, save the settings and reboot the computer. Verify that the IDE device is set up as Auto or CD Drive. Once connected, turn on the computer and enter BIOS setup. If you experience problems, you may have to disconnect all the cables again.) (We recommend you do not connect all the cables yet. Connect the keyboard, monitor, and power to the computer. Once the disc drive is connected to the computer, place the case back on the computer. The audio cable will connect to one of the following locations: sound card, motherboard (when onboard sound present), or DVD decoder card. Once the cables are connected to the drive, connect the opposite ends of the IDE/EIDE interface cable and the audio cable to their appropriate locations. This cable is keyed, therefore it should only connect to the computer in one orientation. This side of the cable often points to where the power connects to the CD-ROM drive.įinally, connect the Molex style power cable to the back of the CD-ROM drive. This cable has one side of the cable that is red or blue indicating PIN 1.

Next, connect the 40-pin IDE/EIDE interface cable (large gray ribbon cable) to the back of the CD-ROM drive. While it may be possible for the cable to connect to these pins, this could cause additional issues. Make sure you are connecting this cable the cable plug and not the jumpers on the back of the drive. When connecting this cable to the CD-ROM drive, it should be a 3 or 4 pin cable connection (see above picture). The CD-ROM should have two cables connected to it and may have an audio cable, which is the smallest of the cables. Having the drive as the primary helps prevent buffer underruns when creating a CD. We recommend when installing a CD-R or CD-RW drive that the drive be set up as the primary drive on the second IDE/EIDE interface.